A very simple tutorial about setting up a Navigation Terminal controlled turret system. You just need 1 atan component and 4 wires.
The Basic Design
- Place atan component.
- Navigation terminal: Velocity_x_out > atan component: Signal_in_x
- Navigation terminal: Velocity y_out > atan component: Signal_in_y
- Atan component: Signal_out > liberar: Position_in
- Navigation terminal: Signal_out_1/2/3 > liberar: Trigger_in
And you are all set!
Using a periscope to control the turret automatically overrides the system so it’s very good.
This is best used with manual fire weapons, and with full auto, weapons use the design below.
Autofire Mode
Você vai precisar 1 atan component, 1 memory component, 1 relay component, e 6 wires.
- Set up the same atan circuit above.
- Navigation terminal: Signal_out_1/2/3 > Relay component: Toggle_state
- Relay component: Check the box off saying: (está ligado)
- Memory component: value=1
- Memory component: Signal_out > Relay component: Signal_in_1
- Relay component: Signal_out_1 > liberar: Trigger_in
Now it will fire in autofire mode.
These are simple circuits that you can use on your sub, aproveitar!
Isso é tudo o que estamos compartilhando hoje para isso Barotrauma guia. Este guia foi originalmente criado e escrito por Cengaver_. Caso não atualizemos este guia, você pode encontrar a atualização mais recente seguindo este link.