This guide teaches you how to make a gas filtration system in Papes that works better and can be used again.
Required Parts
Here are the required parts that you need to make this gas filtration system work.
- x1 Atmos Kit Cycled to Filtration per gas being filtered
- x2 Filters (Medium or heavy recommended)
- x2 copper cable per filtration
- x25 pipe or insulated pipe per gas
- Copper wire for the distance needed to reach your power system.
- x1 power controller
- x1 Gas tank or insulated Gas Tank
- x1 Gas tank or insulated Gas Tank per gas collected
- x1 Turbo pump gas (pick one or more gas sources)
- x1 or more Active vent
- x1 or more ice crusher + volume pump
- x1 furnace exhaust input (lots of pipe running from furnace to filtraion area)
- Other gas source
(Opcional)
- x1 pipe analyzer per gas
- x1 pipe heater per gas
- IC logic parts not listed
How to Setup
Place one long pipe on a side.
Put another long pipe beneath or above for waste gases.
Connect the unfiltered Filtration output (front face) to the waste gas pipe.
At the end of your chain of Filtration units, link the waste line to a turbo pump that connects back to the main input line. This minimizes pressure in the waste line, making Filtration units work faster due to pressure difference.
Finalmente, connect each filtered output to the filtered storage tank. The longer and more spread apart the lines and Filtration units, the easier it is to pull needed lines for gas mixing and expand storage later.
If running this system outdoors, use insulated materials. Temperature control prevents liquid buildup, or use a condensation valve and purge valve to cycle liquids out and gases in as needed (may cause freezing liquids and high gas temps).
Isso é tudo o que estamos compartilhando hoje para isso Papes guia. Este guia foi originalmente criado e escrito por Taparu. Caso não atualizemos este guia, você pode encontrar a atualização mais recente seguindo este link.