SIM 세계를 훈련시킵니다 2 – DB BR 112.1 Start-Up and Operating Guide

Based on the tutorial included with the Train Sim World 2 Haupstrecke Hamburg-Lübeck route, this guide provides complete instructions for operating the DB BR 112.1 engine.

단계 1: Enter Loco

Walk to the door located on the right side of the engine and open the door by clicking on it. Look down toward the bottom of the door and press E to climb into the engine. Look left and click the door to close it.

단계 2: Activate Battery

단계 3: Select Pantograph

단계 4: Enter Cab and Sit in Driver’s Chair

단계 5: Insert Reverser Handle

단계 6: Set Reverser to Forward

단계 7: Wait for Air System to Charge

단계 8: Set Signal Lights to White

단계 9: Set Pantograph control to Raise

단계 10: Set Circuit Breaker to Close

단계 11: Set Passenger Door Selector

단계 12: Set Passenger Doors Switch to Open

When loading is complete, set Passenger Doors Switch to Closed.

단계 13: Set Brake Key to On

단계 14: Set Train Brake to Running

단계 15: Set Handbrake to Release

단계 16: Set Force Selector to 100%

단계 17: Set Speed Selector

추가 참고 사항

• The Speed Selector (일명. Force Selector) operates in 10 KPH increments only.
• 에 대한 1 KM before the next station stop, set the Force Selector to 0 (not off) to begin slowing the train.
• Use the train brake if necessary.
• Stop at the marker.
• Check the Door Selector for proper side setting.
• Open and close doors when prompted to do so.

These instructions are based on the DB BR 112.1 tutorial included with DTG’s TSW2 Haupstrecke Hamburg-Lübeck route. Scenarios or sessions that begin with the driver sitting in the cab probably do not require some of the preliminary steps included here. 어떤 경우에는, initial instructions will be provided in the activity, but this is not always the case.