Sentiment – Guide complet des solutions de puzzle

This guide will show you the complete puzzle solutions in Sentiment. These puzzles include the 4 puzzle chambers and Headquarters. This information clearly contains spoilers for the four logic puzzles and the boss chamber. toutefois, to make this resource also helpful, je’ve organized separate solution and map sections for each subheading.

Chambre 4

Solution

• Configurez-le comme ça. Pour être honnête, il’s not much of a puzzle if you’ve used splitters before.

Chambre 3

Solution

• To make things simple, start from the end. The first device you connect is always in port 0. Choose which line is your « dans » and which is your « dehors ». Alors, add repeaters between them, beginning from the end. Make sure port 0 is where you want it. Après cela, add your splitters. If you want an easier way, just use repeaters and don’t connect to the filters at all. Mais soyez conscient, this might be a mistake in the design and could be fixed later.

Chambre 2

Solution

• This puzzle is all about figuring out the paths. Configurez-le comme ça.

Chambre 1

Solution

• This puzzle is about making a device that works like a traffic cop. You need to separate the lines coming in and going out. On the incoming line, create groups of filters, each group for a certain range of addresses.

Quartier général

Solution

• Two rooms, labeled 13 et 11, begin locked and get unlocked in the first step. I suggest guiding the wires through rooms (2,1) et (2,3) initially and avoiding further adjustments, as these rooms keep refilling and can cause navigation challenges.

Detail Steps

• Adjust the rotations for each splitter as indicated. In room (1,1), set the rightmost splitter’s rotation according to the red line.
• Make a packet travel from 00 > 10 > 12 > 00. Pour y parvenir, itinéraire 10 through a new wire between rooms (3,3) et (1,2). It might be faster than using existing wires.
• Sequentially connect all EPs in this order: 00 > 10 > 00 > 11 > 00 > 12 > 00 > 13 > 00. Pause the network, disconnect the recently added red line, introduce a splitter in room (1,3), and modify the rotation of the rightmost splitter in room (1,1) to match the purple line.